Capabilities
Each capability stands on its own, and they combine into a single scope when a project needs the whole route from plate to commissioned equipment.
Mechanical cleaning, grinding, degreasing and abrasive preparation to SA 2, SA 2½ and SA 3. Anchor profile confirmed by gauge before the first coat, because every coating system on the market assumes the substrate underneath it was done properly.
Grit, shot and garnet blasting for structural steel, vessels, tanks and pipework. Carried out in our shop or at your site with controlled containment and spent-abrasive handling.
Epoxy, polyurethane, zinc-rich primer, high-build and specialist coating systems applied to your specification, with dry film thickness recorded coat by coat.
Airless spray and conventional application for plant structures, sheds, equipment and process lines — including colour coding to plant standards.
Platforms, skids, supports, walkways, ladders and heavy structural steel fabricated to drawing under qualified weld procedure, with dimensional checks before finishing.
Process vessels, reactors, columns and receivers in carbon steel and stainless grades, complete with dished ends, nozzles, jackets and internals.
Shop-built and site-built storage tanks for water, solvent, chemical and utility duty, supplied with manways, fittings, supports and finish system.
Removal of weld scale, heat tint and embedded free iron from stainless steel, followed by passivation to restore the chromium oxide layer and corrosion resistance.
Electrochemical finishing for hygienic and pharmaceutical stainless surfaces — lower Ra, improved cleanability and reduced particle entrapment.
Batch and one-off manufacture of industrial equipment and components, built to your drawing, your sample, or reverse-engineered from an existing part.
Transport, erection, alignment, piping tie-in and commissioning support delivered by our own site crews rather than subcontracted labour.
Detail drawings, GA layouts, material take-off and fabrication documentation prepared alongside your project engineering team.
How we work
A fixed six-stage route, so you always know what happens next and what gets recorded.
Scope, service conditions, specification and site constraints established up front.
Drawings, GA layouts and material take-off prepared and approved before cutting.
Cutting, rolling, welding and assembly to procedure, with dimensional checks.
Blasting, pickling or polishing to the required standard, profile verified.
Coating system applied in sequence, with DFT and holiday testing recorded.
Transport, erection, alignment, commissioning support and documentation.
Budgetary or firm — we quote fabrication, blasting and coating scopes on the same enquiry.
